Mavic ID360 freehub replacement - explained quickly and simply
Does the freehub on your Mavic ID360 hub need replacing? No problem - the replacement is much easier and faster than many people think.
In this guide, we show you step by step how to replace the freehub on your Mavic ID360 hub - without any special tools.
- Pull off the old freehub
- Check the spring
- Push on the new freehub
- Install the end cap
- Keep riding 🚴
1. Remove the old freehub
The old freehub can simply be pulled off the Mavic ID360 hub by hand.
Depending on its condition, this may sometimes be a little easier or more difficult. In most cases, no tools are required.
Important: Do not lever forcefully or twist it.
2. Check the spring
After removing the freehub, be sure to check the spring inside.
👉 This spring must remain in the hub.
Sometimes it remains stuck in the old freehub. Therefore, always check briefly before installing the new freehub.
If the spring accidentally remains stuck in the old freehub, carefully remove it and insert it correctly again.
3. Install the new freehub
The new freehub can now simply be pushed into place.
The matching end cap is then installed.
👉 In most cases, the old end cap can continue to be used.
Once everything is correctly installed, the freehub engages smoothly and sits firmly.
Why the Mavic ID360 system is popular
- Very easy freehub replacement
- No special tools required
- Quick maintenance
- Ideal for straightforward repairs
Conclusion
Replacing the freehub on the Mavic ID360 hub is definitely one of the easier jobs on a bike.
With just a few simple steps, the old freehub is removed and the new one installed - quickly, easily, and without much effort.